Electric Connections - Beninca BOB 50M Handbuch

8) ELECTRIC CONNECTIONS

The cables necessary for the installation of BOB can vary according to the accessories installed.
No connection cable is supplied.
Fig. 7 indicates the cables for standard installation.
List of cables
Connection
A Mains power supply to the control unit
B Motor connection
C Photocell transmitter connection
D Photocell receiver connection
E Key selector connection for external command
F Flashing signal light connection
G Connection of the aerial built-in the flashing light
Legenda
1 Motoreducer
2 Photo-electric cells
3 Key selector (external) or digital keyboard
4 Flash-light
5 Electronic board
The cables used must be suitable for the type of connection. For example, for connection protected by raceways use
H03VV-F cables, for cables in the outdoor environment always use the H07RN-F type.
TECHNICAL DATA
14
Type
3x1,5mm 2
4x1,5mm (3x0,5mm BOB 50ME)
2 2
2x1,0mm
2
4x1,0mm
2
2x1,0mm
2
2x1,5mm
2
RG 58
BOB50M/BOB50ME
230Vac 50/60Hz
310 W
1,4 A
3500 N
30%
IP44
-20°C / +50°C
9 μF
600 kg
455 mm
485 mm
520 mm
0,7 m/min
<70 dB
Permanent grease
11,6 kg