U.N.O. Speed Master 1.8M Aufbau- & Benutzerhandbuch Seite 31

Maintenance Information
LUBRICATING THE RUNNING BELT
Dependent upon usage and user weight it will be necessary periodically to
lubricate the underside of the Running Belt.
To ensure that this is done successfully, take the 5mm Allen Wrench and adjust
the Rear Roller Location Bolts, which are accessible through the Rear Frame Caps.
Rotate each bolt a full 4 turns ANTI-CLOCKWISE to slacken off the belt.
Lift the sides of the belt and run a small bead of lubricant onto the Running
Board and if possible spread this with a small brush or cloth to ensure even
coverage on the Running Board.
Re-tighten the Running Belt by adjusting the Rear Roller Location Bolts
CLOCKWISE until the belt is running centrally on the Running Board.
Please see table below for suggested lubrication frequency.
Please follow the guide below to ensure efficient operation of your
Treadmill.
Light Use of up to 3 hours per week – Lubricate every 8 months
Moderate Use of up to 5 hours per week – Lubricate every 4 months
Heavy or Extended Use over 5 hours per week – Lubricate every 3 months
Your Treadmill Running Deck has been pre-lubricated at the factory and should
need no immediate attention. Please refer to the enclosed maintenance advice
for the lubrication schedule. A suitable Silicon lubricant can be purchased either
from us directly, or from most hardware/DIY stores.
31