Maintenance Information - U.N.O. Speed Master 1.8M Aufbau- & Benutzerhandbuch

Maintenance Information

ADJUSTING THE RUNNING BELT TRACKING
CAUTION: Always unplug the power cord from the wall outlet before using the appliance
clean or wait.
If the Running Belt tends to move off central during operation, step off the
belt and stop the Treadmill.
Start the Treadmill in Manual Programme Mode and adjust the speed to 3mph.
Take the 5mm Allen Wrench and adjust the Rear Roller Location Bolts,
which are accessible through the Rear Frame Caps.
If the belt is moving towards the RIGHT side of the Treadmill Running
Board, turn the RIGHT Rear Roller Location Bolt 1/4 turn CLOCKWISE
and let the Running Belt find its new position. If it is still moving
towards the RIGHT side of the Treadmill Running Board, turn the Bolt
a further 1/4 turn.
If the belt is moving towards the LEFT side of the Treadmill Running
Board, turn the LEFT Rear Roller Location Bolt 1/4 turn CLOCKWISE
and let the Running Belt find its new position. If it is still moving
towards the LEFT side of the Treadmill Running Board, turn the Bolt
a further 1/4 turn.
Continue this operation until the Running Belt is running centrally.
Please take care to ensure that the Running Belt does not
foul the Side Strips, as this will cause premature wear to both the
Running Belt and the Side Strips.
30