Product Safety Information; Product Specifications - Ingersoll-Rand 2161P Technische Produktdaten

Product Safety Information

Intended Use:
These Air Impact Wrenches are designed to remove and install threaded fasteners.
For additional information refer to Product Safety Information Manual Form 04580916.
Manuals can be downloaded from ingersollrandproducts.com.

Product Specifications

Model Style
Type
2161P Pistol Square
2161XP Pistol Square
Square
2161XP-6 Pistol
extended
Square
2171P Pistol
(Pin Retainer)
2171XP Pistol Square
Square
2171XP-6 Pistol
extended
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 47132600 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size
04576856_ed7
Recommended
Drive
Impacts
per
min.
Size
3/4" 1025
3/4" 1025
3/4" 1025
1" 1025
1" 1025
1" 1025
WARNING
Sound Level dB(A)
Torque Range (ISO15744)
† Pressure
ft-lbs (Nm)
(L
300-1000
95.0
(407-1356)
300-1000
95.0
(407-1356)
300-1000
95.0
(407-1356)
300-1000
95.0
(407-1356)
300-1000
95.0
(407-1356)
300-1000
95.0
(407-1356)
* K = Measurement uncertainty Vibration
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease - during assembly
11. Grease - through fitting
Vibration
(m/s²)
(ISO28927)
‡ Power
Level
) (L )
p w
106.0 11.5
106.0 9.8
106.0 9.8
106.0 11.5
106.0 10.3
106.0 9.9
EN
*K
3.8
1.8
1.8
3.8
1.3
3.0
EN-1