Husqvarna LC 141iV Bedienungsanweisung Seite 20

To use the SavE function
The product has a battery saving function (SavE) that
gives longer operation time.
1. Press the SavE button (A) to start the function. The
green LED comes on. (Fig. 51)
2. Press the SavE button again to stop the function.
The green LED (B) goes out.
The SavE function stops automatically if the ground
conditions make it necessary to have a higher output.
The SavE function starts automatically when the ground
conditions lets it.
High load function
When the product cuts long or wet grass, the motor
automatically increases rpm. The motor goes back to
standard mode when high load is not necessary.
To stop the product
The product stops automatically if you do not operate it
for 10 minutes. Always turn the safety key to 0 before
you let the product out of view.
1. Release the motor brake handle to stop the motor.
(Fig. 26)
2. Press the ON/OFF button (A) on the control panel
and the green LED (B) goes out. (Fig. 52)
3. Open the battery lid and turn the safety key to 0.
(Fig. 53)
4. To remove the battery, press the 2 release buttons
and pull out the battery. (Fig. 54)
5. Charge the battery if it is weak. For more
To charge the battery on page 19 .
information, see
To operate LC 141C
To select an approved cable (LC 141C)
Note: For the UK market, use only the 16M extension
cable that comes with the product. For all other markets,
refer to the information below.
If extension cables are used, these must comply with the
minimum cross-sections in the table below:
Voltage
220-240V/ 50Hz
220-240V/ 50Hz
20
Cable Cross sec-
length tion
2
Up to 20 m 1.5 mm
2
20–50 m 2.5 mm
• Mains cables and extension cables are available
from your local approved service agent for
Husqvarna outdoor products.
• Only use extension cables specifically designed for
outdoor use and which conform to one of the
following specifications: Ordinary rubber (60245 IEC
53), Ordinary PVC (60227 IEC 53) or Ordinary PCP
(60245 IEC 57)
• If the cable is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
To start the product
1. Connect a power cord to the socket below the
handle. (Fig. 55)
2. Put the power cord in the power cord holder. Refer
To use the power cord holder (model LC 141C) on
to
page 14 . (Fig. 29)
3. Stay behind the product.
4. Loosen the start inhibitor. (Fig. 56)
5. Push the motor brake handle in the direction of the
handlebar. (Fig. 57)
To stop the product
1. Release the motor brake handle to stop the motor.
(Fig. 58)
2. Disconnect the power cord from the mains and then
from the product. (Fig. 59)
CAUTION: Pull the plug straight out. Do
not pull the power cord.
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
919 - 003 - 23.10.2019