Parts; Adaptor Installation - Panasonic CZ-TACG1 Benutzerhandbuch

Parts

Adaptor Unit
(CZ-TACG1)
Screw for mounting
(M4 x 20 – 1 piece)
Mounting cord clamp
(1 piece)
Cable tie (1 piece)
Double-sided
adhesive tape
Wall plug

Adaptor Installation

1. Attach the Adaptor unit with double-sided adhesive tape
on the wall near the indoor unit.
- Shut off the power supply when installing this adaptor.
- Make sure the wall is clean and free from dirt.
2. Use the cord clamp to fi x the cable to the wall.
Pull the cable around as shown in the diagram so that the external force cannot
act on the connector in the adaptor. Furthermore, on the indoor unit end, use
the included cable tie to fi x the cables together when necessary.
General illustration for
installation use
3. Connect the cable to the CN-CNT connector at the indoor
unit.
Take note each indoor unit CN-CNT connector location might be different.
Please consult authorized dealer.
5
Adaptor
Adhesive tape
Wall
Cable tie
L N 1 2 3
Cord clamp