Herunterladen Inhalt Inhalt Diese Seite drucken

Defrost And Clean The Freezer Compartment - Bosch GSL Serie Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für GSL Serie:
Inhaltsverzeichnis

Werbung

en
Defrost and clean the
freezer compartment
Risk of electric shock
!
NEVER use a steam cleaner. If live
components come into contact with
condensing steam, they may short circuit
or cause an electric shock.
Explosion hazard
!
Defrosting sprays may form explosive
gases and/or contain solvents or
propellants which corrode plastic and/or
may be a health hazard.
Follow the manufacturer's instructions.
Warning
!
Do not remove the frost with a knife or
other sharp object. Be careful not to
damage the refrigerant circulation pipes.
Ejecting refrigerant can ignite itself or lead
to damage to the eyes.
Do NOT place any electric appliances
or naked flames in the appliance.
Notes
Large accumulations of ice or hoar frost
on the freezer grids impede the efficiency
of the appliance and cause the rate of
energy consumption to increase.
If the layer of frost is greater than 5 mm
then the appliance should be defrosted. In
any case it should be done at least once
or twice a year. Most appropriately when
there is very little or no frozen food in the
freezer.
26
Procedure
S Switch the appliance off and remove the
mains plug.
S Store the freezer drawers and the food
in a cool location. Place the ice block (if
enclosed) on the food.
S Empty the top frozen food bin and place
it directly under the drainage outlet to
collect the thaw water. Fig. q
S To speed up the defrosting process
place two saucepans with hot water on
a base in the appliance.
S When the freezer compartment has
defrosted, empty the water which has
collected in the freezer tray. Mop up any
water in the bottom of the freezer
compartment with a sponge.
S Clean with water and a little detergent.
S Switch on the appliance.
S Put the frozen food back into the freezer
compartment.
Warning
!
Do NOT use abrasive or acidic cleaning
agents or solvents.
Clean the door seal with water only and
dry thoroughly.
No water should be allowed into the
control panel during cleaning.

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis