Positioning; Aligning The Appliance; Changing Over The Door Hinges - Bosch GSL Serie Gebrauchsanleitung

Positioning

The appliance should be installed in a dry,
well ventilated room, but not exposed to
direct sunlight and not placed near a heat
source, e.g. a cooker, radiator, etc. If
installation next to a heat source is
unavoidable, use a suitable insulating
plate or comply with the following
minimum distances to a heat source:
3 cm to an electric cooker.
30 cm to an oil or solid fuel cooker.
If installing the appliance next to another
refrigerator or freezer, ensure that there
is a gap of at least 2 cm between the
appliances to prevent condensation.
Installation under a worktop
Fig. 1
Do not install hotplates above the
appliance!
Do not remove the worktop frame!
Appliance ventilation
A ventilation cross section of
2
minimum 160 cm is necessary for
installation below a worktop. For this
purpose, a vent measuring about
500 x 60 mm is required, which is
available from DIY shops or specialist
retailers.
S Mark the cut out for the vent on
the worktop centric to the appliance.
S Max. distance to wall 83 mm
S Note width B" of the wall connection
rail!
S Saw out the cutout. Chamfer
the underside by approx. 4 mm.
S Insert and attach the ventilation grille.
Note
The vent is not required when
the distance between the worktop
and appliance is more than 5 cm.

Aligning the appliance

Fig. 2
The appliance must be level. If the floor
is uneven, use the front height adjustable
feet.
Changing over the door
hinges
d
Warning
While changing over the door hinges,
ensure that the appliance is not
connected to the power supply.
Pull out the mains plug beforehand.
Tilt back the appliance (if required, place
packaging material, etc. underneath).
Figure 3
The door hinges can be changed over
if required by the installation location.
Proceed in numerical sequence.
en
19