Possible Fault; Troubleshooting A Cable-Tie Bandoleer; Malfunction - HellermannTyton Autotool 2000 CPK Betriebsanleitung

9.4

Possible fault

FAULT PATTERN
Loops form
Binding not possible.
Cable tie shoots straight
out.
Cable tie is not cut off
lush.

9.4.1 Troubleshooting a cable-tie bandoleer

malfunction

Be sure to check the information on the display, à "Display
messages" on page 25.
f Switch the power pack OFF.
1
f Push actuator for bandoleer cutter
f Press catch
.
3
f Open gate
.
1
f Press actuator for service lap left
f Open the left service lap.
f Open the right service lap.
Operating Instructions • AT2000 CPK • 02-2017 • v02 • 106-29004
POSSIBLE CAUSE
• Bundle diameter is
unsuitable.
• Tie advancer is not in the
correct position.
• Spring in upper jaw is faulty.
• Lower jaw is blocked.
• Upper jaw is blocked.
• Cutter in front cap is not in
correct position.
to the left.
2
4
.
4
SOLUTION
f Use a suitable bundle diameter, à "Positioning and
binding items for bundling" on page 12.
f Check the position of the tie advancer, à "Checking
tie advancer" on page 31.
f Check upper jaw lap in upper jaw with spring,
à "Replacing upper jaw" on page 30.
f Check lower jaw, à "Checking front cap and position
of cutter" on page 31.
f Remove blockage.
f Check upper jaw, à "Checking upper jaw" on
page 30.
f Remove blockage.
f Check position of cutter in front cap and remove
cable-tie residues, à "Checking front cap and position
of cutter" on page 31.
2
3 f Turn drum
past the point of indexing resistance and
5
remove the cable-tie residues.
f Close the left and right service laps.
f Switch the power pack ON.
f Close the gate.
f Load a new cable tie bandoleer, à "Loading cable ties"
on page 11.
Troubleshooting
5
28