Product Safety Information; Product Specifications - Ingersoll-Rand 61H Serie Technische Produktdaten

Product Safety Information

Intended Use:
These Air Die Grinders are designed for grinding, porting, polishing, de-burring, and
breaking sharp edges.
● Do not attempt to disassemble the internal Speed Controller. It is available only as a
unit.
● Before installing a new Arbor Housing Assembly, always select the correct Nameplate
Kit and secure it to the Arbor Housing with the Nameplate Screws.
For Additional information refer to Air Die Grinder Product Safety Information Manual
Form 04580288.
Manuals can be downloaded from www.ingersollrandproducts.com

Product Specifications

Free Speed
Model(s)
rpm
61H120G4-EU 12000
61H150G4-EU 15000
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16576134 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
16576118_ed2
WARNING
Sound Level dB(A)
(ANSI S5.1-1971)
Collet Size
Pressure
1/4" 86.6
1/4" 89.8
7.
8.
9.
10. Oil
11. Oil (Fill Oil Chamber, if applicable.)
Power (ISO3744)
99.6
102.8
Coupling
Safety Air Fuse
Hose Whip
EN
Vibration
(ISO28927) m/s²
Level
<2.5
<2.5
EN-1