Safety Notes; Installation Instructions; Symbol Description - HANSGROHE Exafill series Gebrauchsanleitung, Montageanleitung

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may not be used as a holding handle. A
separate handle must be installed.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• Connection with flexible hose code nr. 58192000.
(see page 34) Fig. A
Installation to DIN 1988
(see page 34) Fig. B
When installing a different flush-type fitting than the iBox
universal, DIN EN 1717 requires the pipe interruptor
(DB) to be at least 150 mm above the tub brim.
Installation to EN 1717
(see page 34) Fig. C
Use of the flush plug
(see page 34) Fig. D
• Testfilling of the bath tub.
• Flushing of the pipes.
• Pressure test of the pipes between mixer and flush
plug
• The residual water jet during pressure test is taken
into account. It shall remind you of closing the mixer
after the pressure test and avoid cross flow at the
mixer.
Technical Data
Sequence power:
overflow capacity:
The product is exclusively designed for drinking water!

Symbol description

Do not use silicone containing acetic acid!
Dimensions (see page 31)
Flow diagram (see page 31)
Spare parts (see page 39)
4
English
53 l/min
36 l/min
Assembly (see page 32)
Special accessories
(order as an extra)
connection hose #58192000 (see page 39)
Cleaning (see page 36)
Operation (see page 35)
Test certificate (see page 35)