Preparing For Use; Using The Appliance - Philips Suncare Bedienungsanleitung

ENGLISH
6
Duration of the tanning session
for each separate part of the
body
1st session
rest of at least 48 hours
2nd session
3rd session
4th session
5th session
6th session
7th session
8th session
9th session
10th session
*) or longer, depending on your skin
sensitivity.

Preparing for use

1 In transport position the appliance can be easily moved and stored because it has wheels (fig. 2).
B The appliance is easier to lift if you do so together with another person.
NB:The appliance weighs more than 28 kg.
B
2 Unlock the lamp unit from the base by pushing the slides in the direction of the arrow (fig. 3).
3 Pull the stand and the lamp unit upwards (fig. 4).
4 Put the tanning appliance in the position shown in the picture (fig. 5).
5 Pull the lamp unit up into horizontal position by means of the handgrip (fig. 6).
You will hear clicks when you move the lamp unit past certain fixed positions.
B
6 Instead of using the above step-by-step method described, you can also pull the lamp unit up by its handgrip in one single movement
(fig. 7).
Hold the handgrip.
B
7 Turn the lamp unit a quarter turn (fig. 8).
When you have done this, the tanning appliance will have been folded out into the position shown in the figure (fig. 9).
8 Place the tanning appliance beside a bed as shown in the figure (fig. 10).
9 Unlock the locking collar for height adjustment by sliding the collar downwards. Slide out the stand with your other hand until the lamp
unit is approx. 85 cm above the bed (fig. 11).
Use the measuring tape to check the distance between the bed and the lamp unit.
10 Let go of the collar to lock the lamp unit in position.

Using the appliance

Setting the timer (HB823 only)
1 Fully unwind the mains cord.
2 Insert the mains plug into the wall socket.
3 Consult the memory knobs and the table in these instructions for use.
4 Put on the protective goggles supplied.
5 Set the timer to the required tanning time (fig. 12).
6 Lie down under the lamp unit.
Once the set time has elapsed, the timer will switch off the tanning appliance automatically.
NOTE: the timer can be set up to a maximum of 60 minutes. If you wish to tan both sides of your body directly after each other, we advise you to
B
reset the timer just before the set time has elapsed. By doing this, you can avoid the 3-minute waiting period which would otherwise be necessary
before the lamps can be switched on again.
for persons with very sensitive
skin
7 minutes
10 minutes
10 minutes
10 minutes
10 minutes
10 minutes
10 minutes
10 minutes
10 minutes
10 minutes
for persons with normal
sensitive skin
7 minutes
20-25 minutes
20-25 minutes
20-25 minutes
20-25 minutes
20-25 minutes
20-25 minutes
20-25 minutes
20-25 minutes
20-25 minutes
for persons with less sensitive
skin
7 minutes
30 minutes*
30 minutes*
30 minutes*
30 minutes*
30 minutes*
30 minutes*
30 minutes*
30 minutes*
30 minutes*