Seav LRX 2214 SWR Handbuch Seite 12

F I - I
OR THE NSTALLER MPORTANT
- The control unit was designed to enable the installer to auto-mate sun blinds and
rolling window shutters adhering to the provisions set out by current legislation.
Compliance with these obligations and the implementation of the minimum safety
re-quirements is the responsibility of the installer.
We recommend installation is performed in full compliance with EN 60335-2-97
("Household electrical appliances and similar - Safety", part 2 "Particular require-
ments for drives for rolling shutters, awnings, blinds and similar equipment).
In this regard, realise the plant combined with this components control unit (motor,
mechanical parts, etc.) resulting conform in satisfying the necessary safety requi-
sites.
- The control unit must be permanently connected to the power supply network and
is not equipped with any type of 230 V a/c electric line sectioning device. The
installer is responsible for installing a sectioning device in the system. An omnipolar
switch with overheating category III must be installed. It must be positioned in such
a way that it is protected against acci-dental closures.
- For connections (power supply and motor output) we recom-mend the use of flex-
ible wires with an insulating sheath in harmonised polychloroprene (H05RN-F). The
wires should have a minimum cross-section of 0.75 mm
- Fasten the connection cables using the cable clamp sup-plied with the product kit.
- In choosing the motor to combine with the control unit, keep to the maximum
power indications contained in this manual.
- For the radio receiver to operate correctly when two or more control units are used,
we recommend that you install the devices at least 3 metres away from each other.
- If two or more control units are installed, we recommend only one Wireless Sensor
is used in order to avoid radio in-terference.
2
- 12 -
F U - I
OR THE SER MPORTANT
- The device should not be used by children or by individuals with reduced physical
or psychological abilities unless supervi-sion is provided or instruction given on how
to operate it.
- Do not let children play with the device; keep radio controls out of their reach.
- CAUTION: Keep this instruction manual in a safe place and observe the important
safety instructions contained within it. Non-observance of these instructions may
lead to property damage and serious accidents.
- Examine the system frequently to check for any signs of dam-age. Do not use the
device if it needs to be repaired.
- We recommend carrying out the opening and closing opera-tions of the blind or
rolling window shutter in visible conditions, ensuring no persons are in a dangerous
condition during movement.
Warning
All procedures which require the casing to be opened (such as wire connection, pro-
gramming, etc.) must be carried out during installation, by skilled staff only. For any
other procedure which requires the casing to be opened again (re-programming,
repairs or site modifications), please contact the technical assistance service.
The below products:
LG2214 SWR – LRS2214 SWR
LRS2214 SWR SET – LRH2214 SWR
conform to the specifications in the Directives
RED 2014/53/EU, EMC 2014/30/EU, LVD 2014/35/EU.
Rev. 3.0 13/06/2016