Power Wiring; Solenoid Valve; Water Pump - Thetford COMPASS Short PREMIUM PLUS Bedienungs- Und Einbauanleitung

Wiring Information for Tecma Compass

Power wiring

Tecma Compass Controller

Solenoid Valve

non-water proof connection
Tecma Compass Controller

Water Pump

non-water proof connection
Tecma Compass Controller
Plus Tank Sensor Wiring
Red
Black
Green
White
Tecma Compass Controller
CAUTION!
Dielectric Grease is a possible eye irritant. If contact occurs, rinse eyes with water for 15 minutes. Keep out of reach of children.
Warning!
Water Pumps must be powered by toilet controller as shown above. Do not wire pump directly to a power source so that it is controlled by
its pressure-activated switch. If a leak were to occur when wired directly, the pump would run continuously and create the risk of sinking the boat and loss of
life.
www.thetfordmarine.com
G
Black
10 AWG
Red
F G
14 AWG Blue
Black
27139 (AMP)
Q
Blue
Black
{
Apply dielectric grease to wire terminals before termi-
nals are installed in housings. Grease is included in
the wiring connection kit.
Customer Supplied Wiring Parts
C D
16 AWG Red (recommended)
16 AWG Black
(recommended)
D C
31
Customer Supplied Wiring Parts
Black (Recommended)
Red (Recommended)
Customer Supplied Wiring Parts
B A
14 AWG Blue (Recommended)
14 AWG Black (Recommended)
C D
16 AWG Green
(recommended)
16 AWG White
(recommended)
D C
See Wiring Information chart for correct wire
gauge and circuit breaker sizes
Pin Contact: 0460-204-08141
F
Receptacle: DTHD04-1-8P
Socket Contact: 0462-203-08141
G
Plug Housing: DTHD06-1-8S
Solenoid Valve
Q
Water Pump
Parts included in Wiring ConnectionKit
A
Columbo 27131 (Installed)
B
Socket Contact: 0462-201-16141
C
Plug: DT06-2S
Wedge Lock: W2S
Pins: 0460-202-16141
D
Receptacle: DT04-2P
Wedge Lock: W2P
Black
Full Tank Sensor
Brown
Black
Optional Mid-tank
Sensor
Brown
Tecma Compass Short PREMIUM Owner's & Installation