Bpt KNX/DALI 64/16 Bedienungsanleitung Seite 29

ECG
fault: E 34
KNX
fault
FUNCTION INPUT B1 submenu – Levels 2 and 3
By briefly pressing the "Prg/Set" button key, you can move from the first level
FUNCTION "FUNCTION INPUT B1" menu to a submenu that lets you assign the function to the
INPUT B1 conventional button key or to the presence detector connected to the B1 binary input.
B1: TOG/DIM
ASSIGNMENT
● ON: a switch-on command is sent.
● OFF: a switch-off command is sent.
● TOGGLE pushbutton toggles between ON and OFF
● ON/DIM: the brief closure of the contact causes a switch-on command to be sent; prolonged closure
causes an increase in light intensity and the consequent adjustment stop command when the contact
reopens.
● OFF/DIM: the brief closure of the contact causes a switch-off command to be sent; prolonged closure
causes a reduction in light intensity and the consequent adjustment stop command when the contact
reopens.
● TOG/DIM short push toggles between ON and OFF, long push dims up or down and issues a stop tel-
egram when pushbutton is released. (Single Button Dimming)
● SCENE pushbutton invokes a scene
B1: ON
ALL GROUPS
B1: TOG/DIM
GROUP: 07
FUNCTION INPUT B2 submenu – Levels 2 and 3
By briefly pressing the "Prg/Set" button key, you can move from the first level
FUNCTION "FUNCTION INPUT B2" menu to a submenu that lets you assign the function to the
INPUT B2 conventional button key or to the presence detector connected to the B2 binary input.
A short-circuit on the DALI BUS prevents the device recognising any other fault
that may arise. By contrast, all other error types can be identified simultaneously.
By briefly pressing the "Move" button key within the submenu, you can move
from one error condition to another.
Errors concerning the lamps or ballasts will show the number associated with
the ballast, so the error can immediately be located in the installation.
By pushing the ESC button or by simply waiting for more than 30 seconds, the
parent menu item is again activated.
By briefly pressing the "Move" button key, you can move from one function to
the next. The first row of the display shows the current function. The following
functions are available:
A long push of the Prg/Set button switches the device to programming mode
By briefly pressing the "Move" button key, you can select the group or scene
with which the function must be associated. By briefly pressing the "Prg/Set"
button key, you can confirm the selection and quit the submenu. By pressing
the "ESC" button key, or simply waiting about 30 seconds, the operation is
cancelled and the previous menu reappears.
29