Bpt KNX/DALI 64/16 Bedienungsanleitung Seite 24

This screen features submenus that allow to resynchronize DALI ECGs after a post
POST install (adding or removing ECGs to a previously configured DALI Gateway) by start-
INSTALLATION ing an automatic detection and displaying the modified configuration.
GROUP Within the submenus of this screen, the detected ECGs can be allocated to the de-
ASSIGNMENT sired DALI groups.
GROUP Within the submenus of this screen, the parameters of each group can be set and
PARAMETERS modified.
SCENE The submenus of this screen allow to add DALI groups to DALI scenes.
ASSIGNMENT
GROUP The submenus of this screen allow to switch the entire DALI segment (Broadcast) or
TEST individual DALI groups for testing purposes.
TEST This screen features submenus to invoke individual DALI scenes for testing purposes.
SCENES
SYSTEM This screens leads to submenus that will display all existing system failures individu-
TEST ally.
FUNCTION The submenus of this screen allow to set the function of the binary input B1.
INPUT B1
FUNCTION The submenus of this screen allow to set the function of the binary input B2
INPUT B2
If a function is to be activated or a parameter to be changed within a given submenu, it is necessary to switch
to the so called programming mode by pushing the Prg/Set button for more than 2 seconds.
Once the selected function of parameter is in programming mode, an Arrow symbol appears in the display.
Once the programming mode is active, the MOVE button is used to change the setting or the parameter value.
By pressing the Prg/Set button with a short push again, the programming mode is ended (EXIT and SAVE).
the parameter has been updated with the selected value, or the selected function has been activated.
The ESC button quits the programming mode without saving.
24