Bpt KNX/DALI 64/16 Bedienungsanleitung Seite 28

GROUP:06
TEST
GROUP: 06
->off
TEST SCENES submenu – Levels 2 and 3
By briefly pressing the "Prg/Set" button key, you can move from the first level "TEST
TEST SCENES" menu to a submenu that lets you both execute each DALI scene individually
SCENES (to check they function) and save the current lighting settings, associating them with
a specific scene.
SCENE No.:02 By briefly pressing the "Move" button key within the submenu, you can move from one
TEST scene to the next. The first row of the display shows the number of the current scene.
A long push of the Prg/Set button switches the device to programming mode
By briefly pressing the "Move" button key, you can select the required command (op-
SCENE No :02 tions "->invoke" or "->save" scene), while by briefly pressing the "Prg/Set" button key,
->invoke the command is implemented.
By pressing the "ESC" button key, or simply waiting about 30 seconds, the operation
is cancelled and the previous menu reappears.
SYSTEM TEST submenu – Levels 2 and 3
By briefly pressing the "Prg/Set" button key, you can move from the first level
SYSTEM "SYSTEM TEST" menu to a submenu that lets you display all the error messages
TEST individually.
DALI
fault
LAMP
fault: E 23
28
By briefly pressing the "Move" button key within the submenu, you can move
from one group to the next. The first row of the display shows the number of
the current group.
A long push of the Prg/Set button switches the device to programming mode
By briefly pressing the "Move" button key, you can select the required
command (options "->on" or "->off"), while by briefly pressing the "Prg/Set"
button key, the command is implemented. By pressing the "ESC" button key,
or simply waiting about 30 seconds, the operation is cancelled and the
previous menu reappears.
The display will show any errors.
The following error types are recognised, visualised on the display, and also
signalled by the fixed light of the red "ERR" LED:
- short-circuit on the DALI BUS
- lamp fault with indication of the number of the ballast to which it is connected
- ballast fault with indication of the relative number
- no KNX BUS power supply