Cutting Techniques; Cutting Unequal Margins - KEENCUT ULTIMAT GOLD Gebrauchsanleitung

6.1 Cutting techniques 6.1

Cutting Unequal Margins

1st Cut
3rd Cut
2nd Cut
NOTE: Continue changing the Limit Stops before
making each cut.
4th Cut
English
UNEQUAL MARGINS - Cuting a Mat with UNEQUAL MARGINS, for example 3,3,3 & 4.
Mark the back of the Mat with margin widths on each of the four edges as shown.
Place the Mat under the Cutterbar.
Set the Matguide Limit Stop (blue) to the size shown on the left hand edge of the Mat (to 3 in this case).
Set the Start of Cut Limit Stop (green) to the size shown on the top of the Mat (to 3 in this case).
Set the End of Cut Limit Stop (red) to the size shown on the bottom of the Mat (to 4 in this case).
Make the first cut - turn the mat 90 degrees counter-clock wise .
Set red stop to 3
Make a second cut - Turn the mat 90 degrees counter-clock wise.
Set green stop to 4
Make a third cut - Turn the mat 90 degrees counter-clock wise.
Set green stop to 3
Set blue stop to 4
Make the last cut.
Refer to 'Additional Matguide fittings' when cutting large quantities of Unequal Margin mats.
¹ Cutterbar
KEY: End of Cut Limit Stop Matguide Limit Stop