Inhaltsverzeichnis
Werbung
5.4
b
ADJUSTING THE CUTTER HEAD SLIDE BEARINGS
The bearings which control the sliding motion of the Ultimat Gold cutting head are machined from a remarkable
material called Ultra High Molecular Weight Polyfine and they will never wear out. As the bearings settle into position
you may wish to adjust them to eliminate side play from the sliding head as follows:-
Remove the slip sheet to allow the cutter bar to lay flat on the machine base.
Place the 2mm hexagon wrench in the front bearing adjustment screw (a) and turn clockwise by small increments
(1/16th of a turn) sliding the head each time to check for free running.
When the head slides less easily turn the adjustment screw back counter-clockwise by one small increment or two to
restore free running.
Repeat steps 2 & 3 on the back bearing adjustment (b) first rotating the bevel blade holder to gain access to the head
of the adjustment screw.
NOTE
It is not necessary to remove the head for cleaning and once the bearings are adjusted to your preference you may
never have to do it again.
Maintenance
a
5.4
You will
need
2mm
Werbung
Inhaltsverzeichnis
