Inhaltsverzeichnis
Werbung
4.4
Operation
4.4
Bevel Cutting
English
THE LIMIT STOPS on the Ultimat Gold are colour coded for ease of explanation. Do not alter the cursor settings
at this stage, adjust the limit stops by means of the large black wingknob only, we will explain cursor adjustment later.
Place your slip mat in position.
Lock the Matguide Limit Stop (Blue) on 3 (cms or inches) - this sets the border width.
Lock the Start of Cut Limit Stop (Green) on 3 (cms or inches) - this will position the blade in the correct place when
you start cutting
Lock the End of Cut Limit Stop (Red) on 3 (cms or inches) - this stops the blade in the correct position.
Lift the Cutterbar using the Handle or the Lift and Hold.
Place the matboard coloured face down on the slip mat.
Ensure the two Mat edges are aligned against the Matguide and the End Plate.
Lower the Cutterbar to clamp the matboard and check the matboard contact with the Matguide and End Plate.
¸ End Plate
¹ Cutterbar
KEY:
Handle
Start of Cut Limit Stop
End of Cut Limit Stop
Lift and Hold
Matguide Limit Stop
Werbung
Inhaltsverzeichnis
