The Alignment Of The Matguide - KEENCUT ULTIMAT GOLD Gebrauchsanleitung

5.2
The Alignment of the Matguide T-Bar
(A)
(C)
English
THE ALIGNMENT OF THE MATGUIDE T-Bar with the Cutterbar is checked using the two spacers provided.
Place the thin edge of the spacers under the Cutterbar, one near the top of the Matguide T-Bar and the other near
the bottom.
Move the Matguide T-Bar across to touch both spacers and clamp the wingbolt (C).
If both spacers do not touch the Matguide T-Bar loosen the two Alignment Adjustment Screws (A).
Release the wingbolt (C) and move the Matguide T-Bar to the right touching the Matguide T-Bar on both spacers.
Tighten the wingbolt (C), gently tighten the two Alignment Screws (A), check the spacers now contact the
Matguide T-Bar.
Maintenance
KEY: Matguide T-Bar
¹ Cutterbar
5.2
You will
need
3mm