Klarstein DryFy Connect 30 Bedienungsanleitung Seite 31

Drying function in the air dehumidifier
Press the dry button (2) to activate the dry function of the dehumidifier. The entire process
takes approximately one hour:
1. The dehumidifier runs at high speed and releases air for more than 30 minutes.
2. The dehumidifier changes to low speed and continues running for about 20 minutes.
Interrupt the drying function:
1. If you press the dry button (2) again during the drying function, the drying function
is aborted and the unit resumes its original operating status.
2. Press the On/Off button (7) to cancel the drying function and place the appliance
in standby mode.
Humidity Indicator
Press the humidity button (5) and mode button (6) simultaneously to turn the humidity
indicator on/off. When the unit is in use, the color on the front of the unit changes
depending on the humidity. If the humidity is greater than 60%, the unit will glow red. If
the humidity is between 40% and 60%, the unit will glow green. If the humidity is less
than 40%, the unit will glow blue.
Pump Function (10034434 & 10034435)
If you press and hold the humidity button (5) for more than 3 seconds, the pumping
function is activated/deactivated. (Connect a drain hose before activating the pumping
function.)
Air swing function (10034434 & 10034435)
If you start the timer button (1) and the dry button (2) at the same time, the air swing
function is started or stopped.
EN
31