Turning On The Power - Canon MACRO TWIN LITE MT-26EX-RT Basisanleitung

Turning on the Power

Quick Flash Function
The Quick flash function enables flash photography when the flash-
ready lamp is lit green (before the flash is fully charged). Quick flash is
available regardless of the camera's drive mode setting. Although the
flash output will be approx. 1/2 to 1/6 of the full output, it is useful for
shooting with a shorter firing interval.
During manual flash shooting, this function is available when the flash
output is set to 1/4 or smaller. Note that you cannot use Quick flash with
FEB or during wireless multiple flash shooting.
16
Set the power switch to <K>.
1
The flash recharge starts.
During recharging, <G> is
displayed on the LCD panel. When
flash recharge is complete, this
indicator disappears.
Check that the flash is ready.
2
The status of the flash-ready lamp
changes from off to green (Quick
flash ready), then to red (fully
charged).
You can press the test flash button
(flash-ready lamp) to fire a test flash.