Installing The Batteries - Canon MACRO TWIN LITE MT-26EX-RT Basisanleitung

Installing the Batteries

Install four AA/R6 batteries for power supply.
CAUTION
Do not use "AA/R6 lithium batteries".
Note that certain "AA/R6 lithium batteries" may become extremely hot in rare
cases during use. Due to safety reasons, do not use "AA/R6 lithium batteries".
When performing continuous flash, do not touch the flash unit,
batteries, or the area near the battery compartment.
When continuous flash or modeling flash is repeatedly fired at short
intervals, do not touch the flash unit, batteries, or the area near the battery
compartment. The flash unit, batteries, and area near the battery
compartment may become hot, resulting in the risk of burn.
Do not allow the product to maintain contact with the same area of
skin for extended periods of time during use.
This may result in low-temperature contact burns, including skin redness
and blistering, even if the product does not feel hot. The use of a tripod or
similar equipment is recommended when using the product in hot places
and for people with circulation problems or less sensitive skin.
12
Open the cover.
1
Slide the lock-release lever to the left
as shown in the illustration, slide the
cover down, then open the battery
compartment cover.
Install the batteries.
2
Make sure the "+" and "-" electrical
contacts are correctly oriented as
shown in the battery compartment.
The grooves on the side surfaces of
the battery compartment indicate "-".
This is convenient when replacing the
batteries in a dark place.
Close the cover.
3
Close the battery compartment cover
and slide it up.
When it clicks in place, the battery
compartment cover is locked.