Installation Tailpiece And Intermediate Flange - Vetus BOW28548C Bedienungshandbuch Und Einbauanleitung

4 Installation
In order to install the tunnel, consult 'Instal­
lation recommendations for bow thrusters' ,
Vetus art. code 020571.01.
For overall dimensions see drawing, page 65.
n
ote
The areas in which the electric motor
of the bow thruster and the battery are
positioned must be dry and well venti­
lated.
4 .1 Preparation
The bow thruster will be delivered fully as­
sembled. Perform the following steps:
• Remove the propeller.
• Remove the motor from the intermediate
flange.
• Remove the intermediate flange from the
tail piece.
The 2 bushes are only required for trans­
port and are now no longer needed.
4 .2

Installation tailpiece and intermediate flange

• Place one packing between the tail piece and the tunnel.
• Apply a sealant (e.g. polyurethane or silicone) between the tail
piece and packing, and between the packing and the tunnel wall.
• Place the tail piece in the hole in the tunnel.
Any extra packings used should be ones capable of justifying the
tail piece.
*) e.g. Sikaflex®­292.
• Grease the hole of the intermediate flange and position this
flange.
• Check dimension 'H'; it must be between 49 and 54 mm (between
1 15 / " and 2 1 / ").
16 8
• If the dimension 'H' is less than 49 mm (1
gasket between the thrust tunnel and the intermediate flange.
• Check again dimension 'H' .
• Now fit the intermediate flange permanently to the tail piece and
grease the threads of the bolts with 'outboard gear grease' before
inserting and tightening them.
Check for possible leaks immediately the ship returns to wa-
ter .
12
020569.02
15 / "), fit an additional
16
n
ote
H = 49 - 50 mm
(1 15 / "- 2 1 / ")
16 8
Outboard Gear
Grease
vetus® Operation manual and installation instructions bow thruster BOW28548C
H < 49 mm
(< 1 15 / ")
16