Routine Maintenance; Maintenance Schedule - Index FDX HOT CUBE 16/200B Bedienungs- Und Wartungsanleitung

• Carefully rewind the high pressure hose (35) without making any kinks in it.
• Follow the instructions for decommissioning as given in the engine operating and maintenance manual.
• The high pressure cleaner must be kept in a dry, clean place paying attention not to damage the high
pressure hose. Engage the brake (40) to avoid any uncontrolled movements of the machine.
NOTE: after a prolonged period of non-use you could find a few drops of water under the pump. This
dripping normally disappears after a few hours of use. If it does persist however, contact a
TECHNICIAN.
Do the operations described in the
Also remember to carry out the routine maintenance jobs given in the engine operating and maintenance
manual, especially as regards to checking engine oil, the air filter and the spark plug.
MAINTENANCE
SCHEDULE
Every time it is used • Check the high pressure hose, fittings, spray gun and lance hose.
If one or more parts are found to be damaged do not, under any circumstances,
• Check the level of pump and gearbox oil by means of indicators (42) and (38) (Fig. 2
• Remove all dirt and debris from the cooling fins on the engine, from the air inlet
Monthly • Clean the water inlet filter (18).
Unscrew the cap (47) with a 27 mm/1,06 in fixed jaw spanner (not supplied) and
Mount the cartridge and screw the plug back down.
• Cleaning the tray filter (11).
Turn the ring nut (34) anticlockwise until it is completely undone; grip the ring nut
• Clean the nozzle.
It is normally enough to put the needle (31) supplied through the hole of the
The professional fixed fan nozzle mounted on the nozzle holder heads (27) can be
• Oil or grease the rotating or sliding parts the operator is able to reach (refer also
• Check soundness of the water inlet and outlet circuits.
• Check tyre inflation pressure.
• Check clamping of the pump to the engine and the engine to the frame.
If clamping is found to be insecure do not, under any circumstances, use the
CAUTION
• When working, the high pressure cleaner should not be too noisy and there should be no obvious drips
of water or oil underneath it. If this is the case have the machine checked by a
DECOMMISSIONING

ROUTINE MAINTENANCE

paragraph and follow the instructions given in the following table.
"STOP"
use the high pressure cleaner and contact a
and Fig. 6). If you need to top up the oil, contact a
grids, from the mechanisms and rev regulator springs (refer to the engine operating
and maintenance manual).
take the cartridge out (51), (see Fig. 5). It is normally enough to put the cartridge
under running water or blow it with compressed air to clean it. In the most difficult
cases, use a scale remover or replace it, contacting an authorised assistance centre
to buy the new cartridge.
(32) with your hand keeping it still and turning the body (33) anticlockwise until it is
completely unscrewed; take the filter cartridge out and clean it as explained above;
in the case of truly stubborn dirt change the cartridge, contacting a
for the right cartridge to use; reposition the cartridge and close the
TECHNICIAN
filter, turning the body (33) right down clockwise and keeping the ring nut (32)
still; reconnect the ring nut (34) turning it clockwise.
nozzle to clean it. If the results are not good, replace the nozzle purchasing it from
an authorised assistance centre.
replaced using a 14 mm/0,55 in box spanner (not supplied).
to the engine operating and maintenance manual).
high pressure cleaner and contact a
JOB
SPECIALIzED TECHNICIAN.
QUALIFIED TECHNICIAN.
SPECIALIzED TECHNICIAN
SPECIALIzED TECHNICIAN
SPECIALIzED
EN
SPECIALIzED
.
.
23