Installation Instructions; Flow Diagram - HANSGROHE AXOR ShowerSelect series Gebrauchsanleitung, Montageanleitung

Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The shower system may only be used for bathing,
hygienic and body cleaning purposes.
Children as well as adults with physical, mental and/
or sensoric impairments must not use this product
without proper supervision. Persons under the influ-
ence of alcohol or drugs are prohibited from using
this product.
The hot and cold supplies must be of equal pres-
sures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be oberserved.
• It is not permitted to install a shutoff device (f.e. a
single-lever mixer) upstream of the built-in valve for 3
consumers!
• If the thermostat or mixer is set to maximum water
temperature, there is a risk of scalding at hydraulical
opening of the check valve. For this reason, Hansgro-
he recommends that you set up the "Safety Function".
Special information for UK
If installing this product with a pump, please be aware
that it has to have negative head switching. This product
will not function with a positive head pump..
Fault
Valve stiff
Shower or spout dripping
Pushbutton cannot be actuated or is
without function
Pushbutton is jammed or stiff
4
English
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
The product is exclusively designed for drinking water!
Symbol description
Cause
- Select stop valve DN9 damaged
- Select stop valve DN9 damaged
- Safety guard of isolating valve has
not been removed
- Seal needs greasing
Assembly see page 31
Do not use silicone containing acetic acid!
Operation (see page 40)
Dimensions (see page 37)

Flow diagram

(see page 38)
Spare parts (see page 39)
Cleaning
see enclosed brochure.
Remedy
- Exchange Select stop valve DN9
- Exchange Select stop valve DN9
- Remove safety guard from isolating
valve
- Grease the seal
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
max. 80°C
65°C
max. 70°C / 4 min