User Instructions; Behaviour Upon The Failure And Resetting Of The Bus Power Supply; Maintenance; Setting The Parameters - Gewiss GW 10 795 Installationshandbuch

Behaviour upon the failure and resetting of the BUS power supply

If power fails on the BUS, the device will not carry out any action. When the BUS power
supply resumes, the thermostat will reactivate the conditions that were in place prior to
the power failure.
The thermostat is not equipped with a buffer battery, so the time must be reset manually
(or automatically, via the BUS, from a KNX device).
The behaviour of the relay (with the drop and subsequent resetting of the BUS power
supply) will be determined by the parameters set during the ETS configuration phase.
The device does not require any maintenance. Use a dry cloth if cleaning is required.
Detailed information about how to set the thermostat parameters is given in the
Programming Manual (www.gewiss.com).
The device must be configured with the ETS software. Detailed information about the
configuration parameters and their values is given in the Technical Manual
(www.gewiss.com).

USER INSTRUCTIONS

Maintenance

Setting the parameters

Programming with ETS

21
E
N
G
L
I
S
H