SUOMY Stellar Bedienungsanleitung Seite 24

position just follow the above procedure, lightly press during initial
EN
phase of the movement until the visor is unlocked. While riding the
motorcycle the visor must never be left in the intermediate positions;
it must always be locked in the locking positions.
Removing — Figure 13
1) Open the visor until it is completely open.
2) Slide the lever (S) and Keep it in tension (S)
3) Remove the visor from its mechanism by rotating and at the same
time by pulling it outwards.
Repeat the operation on the opposite side.
1
2
FIGURE13
24
S
S
3
Assembly — Figure 14
To assure the proper operation of the rotation system of the visor,
before fitting the visor back on, verify that all the parts (seats on
helmet, visor surface in contact with the moving parts) are perfectly
clean.
Open the visor completely. Position the visor on the mechanism so
that the rotation seat is inserted in the rotation ring.
1) Slide the lever (S)
2) Press slightly to stick the hooks on the visor into the slots on the
rotation mechanisms
Repeat the operation on the opposite side.
After fitting the mechanism verify that the visor is tightly fixed to the
helmet, that it rotates freely and that it locks correctly into the locking
positions.
If this doesn't happen and the rotation mechanism of the visor
doesn't work correctly, do not use the helmet and contact Suomy
authorized personnel only
Adjustment — Figure 15
If after replacing the part, or after long use of the helmet, you
experience infiltration from the closed visor, it may be necessary to
2
S
1
FIGURE 14