SUOMY Stellar Bedienungsanleitung Seite 22

PADDING — I — J — K —
EN
The inner padding, can be easily removed to be washed or replaced.
Inner central padding: INNER SHELL — I — Figure 8
Assembly and disassembly
The inner shell (I) is fixed to the helmet through 4 press studs (J).
Removing
Snap to open the press studs (J) and remove the inner shell (I).
Be very careful when removing the shell, press on the rigid part of
the stud and pull slightly towards the inside of the helmet without
damaging the press stud.
Caution: to avoid damages to the inner lining, before removing the
inner shell make sure that all the press studs have been unhooked.
Assembly
Insert the shell (I) inside the helmet checking the assembly direction.
Fasten the press studs (J). After fixing the inner shell, make sure the
shell is correctly positioned inside the helmet (polystyrene padding).
I
22
Inner side padding: CHEEK PADS — K — Figure 9
Assembly and disassembly
Removing — Figure 10
Grab the cheek pad (K) from the front part, push it towards the back
part of the helmet and then rotate inwards until all the press studs
are unhooked.
J J
J J
FIGURE 8
K K
FIGURE 9
K
FIGURE 10