Herunterladen Diese Seite drucken

Instructions Pour L'encastrement; Energy Saving Tips; What To Do If; Correcting Malfunctions - Blomberg GE 1110 Gebrauchsanweisung

Einbau-gefrierschrank-integrierbar

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

2. Defrost the freezer compartment prior to cleaning
(see "Defrosting" section).
3. Switch the appliance off and remove the plug
from the mains, or switch off or turn out the cir-
cuit breaker or fuse.
4. Clean the appliance and the interior accessories
with a cloth and lukewarm water. Commercially
available dish washing detergents may also be
used.
5. After cleaning wipe with fresh water and rub dry.

Energy Saving Tips

• Do not install the appliance near cookers, radia-
tors or other sources of warmth. High ambient
temperatures cause longer, more frequent opera-
tion of the compressor.
• Ensure sufficient air circulation and exhaust at
the appliance base and at the back wall of the
appliance. Never cover air vent openings.
• Do not place warm foods into the appliance.
Allow warm foods to cool first.

What to do if ...

Correcting Malfunctions

A malfunction may be caused by only a minor fault
that you can rectify yourself using the following
instructions. Do not perform any other work on the
appliance if the following information does not provi-
de assistance in your specific case.
Malfunction
Appliance is not switched on
Mains plug is not plugged in or is loose.
Appliance does not work, no pilot light is illu-
minated.
Fuse has blown or is defective.
Socket is defective.
Green light does not light up, yellow light
lights up when fast freeze fuction is activa-
Green light faulty.
ted, appliance is on.
Yellow light does not light up, when fast
Yellow light faulty.
freeze fuction is activated, appliance is on.
Appliance cools too much.
Temperature is set too cold.
26
Accumulation of dust at the condenser
increases energy consumption. For this reason
carefully clean the condenser at the back of
the appliance once a year with a soft brush or a
vacuum cleaner.
• Only leave door open as long as necessary.
• Do not set temperature any colder than neces-
sary.
• Put frozen food in the fridge to defrost. The
cold in the frozen food will then be used to cool
the fridge.
• Keep the heat emitting condenser, the metall
grille on the rear wall of your appliance, always
clean.
Warning! Repairs to refrigerators/freezers may only
be performed by qualified service engineers. Impro-
per repairs can give rise to significant hazards for the
user. If your appliance needs repairing, please con-
tact your specialist dealer or our Customer Service.
Possible Cause
Remedy
Switch on the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be corrected by
an electrician.
Please inform your customer service
Please inform your customer service
Turn the temperature regulator to a warmer
setting temporarily..

Instructions pour l'encastrement

Pièces de montage
Pour des raisons de sécurité, la ventilation doit être
prévue comme indiqué dans le Fig.
Attention: veillez à ne pas obstruer les ouver-
tures de ventilation.
Alignement de l'élément du meuble
Démontage de la porte de l'appareil
Changement du côté d'ouverture de la
porte (si necessarie)
Attention! Pendant le déplacement de la
butée de porte, l'appareil ne doit pas être branché
sur le secteur. Débrancher préalablement la fiche
secteur.
31

Werbung

Kapitel

loading