Appliance Self-Test; Starting The Appliance Self-Test; Ending The Appliance Self-Test; Customer Service - Blaupunkt 5CF35030 Gebrauchsanleitung

Fault
The light does not function.

Appliance self-test

Your appliance features an automatic
self-test program which shows you
sources of faults which may be repaired
by customer service only.

Starting the appliance self-test

1. Switch off the appliance and wait
5 minutes.
2. Switch on appliance and hold down
the super button, Fig. "/2, for
3–5 seconds within the first
10 seconds until an acoustic signal
sounds.
The self-test programme starts.
While the self-test is running, a long
acoustic signal sounds.
When the self-test ends and an acoustic
signal sounds twice, your appliance is
in working order.
If the Super button flashes for
10 seconds and 5 acoustic signals
sound, there is a fault. Inform customer
service.

Ending the appliance self-test

When the programme has ended, the
appliance switches over to normal
operation.
Possible cause
The LED light is defective.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
Remedial action
See chapter "Light (LED)" section.
When the appliance is closed and opened,
the light is on again.

Customer service

Your local customer service
can be found in the telephone directory
or in the customer-service index. Please
provide customer service
with the appliance product number
(E-Nr.) and production number (FD).
These specifications
can be found on the rating plate. Fig. ,
To prevent unnecessary call-outs, please
assist customer service by quoting
the product and production numbers.
This will save you additional costs.
Repair order and advice
on faults
Contact information for all countries can
be found on the enclosed customer
service list.
en
39