Blaupunkt 5CF35030 Gebrauchsanleitung Seite 38

en
Fault
The refrigerating unit
is switching on more
frequently and for longer.
The "cool-fresh"
compartment is too warm or
too cold.
Appliance has no
refrigeration capacity.
The light does not work.
The display does not
illuminate.
Temperature display
indicates "E..".
Appliance is not cooling,
temperature display and light
are lit.
38
Possible cause
Appliance opened
frequently.
The ventilation openings
have been covered.
The standard setting has
been set too high or too low
(e.g. if there is frost
in the "cool-fresh"
compartment).
Appliance has been switched
off.
Power failure.
The fuse has been switched
off.
The mains plug has not been
inserted properly.
Electronics have detected
a fault.
Showroom mode is
switched on.
Remedial action
Do not open the appliance unnecessarily.
Remove obstacles.
The temperature in the "cool-fresh"
compartment can be set to be 3 steps warmer
and/or colder, Fig. ". If the temperature in the
refrigerator compartment is set to 0, the
temperature in the "cool-fresh" compartment
is almost 0 °C.
Note
A change to the standard setting will affect the
temperature in the refrigerator compartment
and freezer compartment.
1. Hold down "super" button 2 for 3 seconds
until temperature display 4 flashes.
2. Change the setting using the temperature
setting button 3.
Setting -3 corresponds to the coldest
setting
Setting +3 corresponds to the warmest
setting
The selected setting is saved after one
minute.
Press the On/Off button.
Check whether the power is on.
Check the fuse.
Check whether the mains plug is secure.
Call customer service.
Hold down alarm button, Fig "/5, for
10 seconds until an acknowledgement signal
sounds.
After a short time check whether your
appliance is cooling.