Wolf ICBDD30 Bedienungs- Und Pflegeanleitung Seite 10

W O L F
G E N E R A L
Most surfaces of your downdraft ventilation
system are stainless steel or aluminum.
Although these surfaces are resistant to most
stains, they are not totally impervious to
damage. Salt and some cooking liquids may
pit and stain the surface. Always remove these
spills immediately.
IMPORTANT NOTE: Be careful not to soak the
control module. Although they are sealed,
excessive moisture may cause damage to the
controls.
10
D O W N D R A F T U S E & C A R E
C A R E
C L E A N I N G
Using a clean cloth or sponge, wipe with warm
water and mild detergent. Rinse and dry
immediately. Apply protective polish, always
in the same direction as the grain.
IMPORTANT NOTE: Do not use steel wool
pads or abrasive cleaners; they will perma-
nently scratch the surface.
IMPORTANT NOTE: Painted surfaces should
be cleaned with warm water and mild deter-
gent only.
Spray Degreasers: Removes fingerprints and
greasy spatters. Spray on a cloth and wipe the
surface. Buff dry immediately to avoid streaks.
Hard Water Stains: Use white vinegar and
water.
Protective Polish: Apply to the surface to
maintain luster and protect from some food
stains. Use a soft, non-abrasive stainless steel
cleaner and apply with a soft lint-free cloth.