Installation; Operating Mode; Maintenance Instructions - Desoutter EAB15-900 Benutzerhandbuch

English
B SCREEN AND BUTTONS
1. Screen
2. Left button
3. Right button
4. Reverse button
C LEDS COLOR CODE
1. Red
2. Green
3. Yellow
The battery pack and the battery charger
are delivered in separate boxes. Please
ensure you have well received these
boxes and check the contents.

INSTALLATION

● Insert the battery pack.
There is no ON/OFF switch: the tool is ready
to operate as soon as a loaded battery pack
is mounted.
● Unplug the battery pack when the tool
is not used.
● Do not leave the battery pack on the
charger when the charger power supply
is off.

OPERATING MODE

When the tool is powered on, the Desoutter logo
is displayed and the LEDs are blinking.
● Wait for a few seconds while the software is
being initialized.
● Refer to the user manual 6159921020 (ExB) /
6159921150 (ExBA) at http://resource-center.
desouttertools.com to learn how to set up
and use the functionalities of the software
embedded in the tool.

MAINTENANCE INSTRUCTIONS

Maintenance should be performed by qualified
personnel only.
● Prior to any maintenance task, disconnect the
tool.
Overhaul and preventive maintenance
is recommended at regular intervals
once per year or after maximum 500,000
tightenings depending on which occurs
sooner.
02/2019
Assembly and disassembly
● When disassembling the tool electronics, take
extra care for the wires when pulling out the
connectors.
● When disassembling the tool front assemblies,
take care for the torque transducer wires.
● Follow standard engineering practices and
refer to figures/exploded view for the mounting
of component subassemblies.
● Prior to putting the equipment back into
service, check that its main settings have not
been modified and that the safety devices
work properly.
Meaning of the pictograms
Left hand thread
When reassembling, apply the
recommended glue
When reassembling, tighten to the
required torque
When reassembling, lubricate with the
required grease or oil.
Lubrication
● Do not apply too much grease on gears or
bearings; a thin coat shall be sufficient.
The use of spare parts other than those
originally supplied by the manufacturer
may result in a drop in performance or
in increased maintenance and level of
vibration and in the full cancellation of the
manufacturer's liability.
According to Directive 2012/19/
CE concerning Waste Electrical and
Electronic Equipment (WEEE), this
product must be recycled.
● Contact your Desoutter
representative or consult the website
"www. desouttertools.com" to find out
where you can recycle this product.
11 / 64
6159930390_15