auna 10034079 Bedienungsanleitung Seite 35

System (DAB)
In DAB mode, press / to show the "SYSTEM" submenu, press the
ENTER button to go to the system setting submenu.
1. Language
Press ENTER to go to language selection; the default source language is
English, the selected language will have "*" displayed at the top right.
Users may choose between "Deutsch", "Italiano" and "Français".
2. Factory Reset
Press ENTER to go to factory reset. If you wish to perform the reset
operation, push the / until "YES" is highlighted on the display and
press. A full reset of your radio will be performed. All presets and station
lists will be erased.
3. SW Version
Press ENTER to view DAB software version. Press Menu or . The
display will return to normal.
Note: If there are no operations after 30 seconds, the display will return to
normal.
Preset
1. Preset Recall: In DAB mode, press / to select "Preset Recall", then
press [ENTER] to tune to the station stored in preset memory.
Note: If you have not previously stored a preset station and the preset
button is pressed, "Empty preset" will be displayed.
2. Preset Store: You may store your preferred DAB stations to the preset
station memories. There are 20 memory presets in your radio. Presets
are remembered by your radio in the event of a power failure.
The procedure for setting presets and using them to tune stations is the
same for DAB modes:
In DAB mode, select the desired wave band. Press   to view
the stored stations, press  or  to tune to the required station as
previously described, and then press ENTER to select the desired preset
number under which you will store the station. Press ENTER to confirm.
EN
35