auna 10034079 Bedienungsanleitung Seite 32

EN
32
Mute Function
Press the MUTE button on remote control, The volume is muted and the
"Volume Muted" will appear on LCD display. Press this button again to
cancel the mute function.
Clock and Timers
Setting the clock and date
After the unit is plugged into a mains supply or following a mains power
failure, the display will show the current time and date on the LCD display.
The unit should be in standby mode to set the current clock.
1. Press CLOCK button, "Time setup" displayed, press ENTER to
confirm,"time wizard interval"displayed.
2. Press / to select "24H" or "12H",Press ENTER confirm.the hour digits
on the display will blink.
3. Press / to set the hour, press ENTER confirm, the minutes digits on
the display will blink.
4. Press / to set the minutes, press ENTER confirm, the Year digits on
the display will blink
5. Press / to set the Year, press ENTER confirm, the Month digits on the
display will blink.
6. Press / to set the Month, press ENTER confirm, the Day digits on the
display will blink.
7. Press / to set the Day, press ENTER confirm. press / the select save
"YES/NO"
Setting Alarm
Note: Check that the radio has the correct time and date before you set an
alarm.
This unit may be used as an alarm clock. The BT device, CD/USB device or
DAB/FM radio is activated to play at a preset time.
1. Press POWER button to switch the unit to standby mode.
2. Make sure that you have set the clock correctly.
3. Press ALARM button in shutdown state; press ALARM twice to set Alarm
2.
4. "Alarm 1 (or 2) Setup" is displayed. Press the ENTER button to select.
5. "Alarm 1 (or 2) Wizard On time" is displayed and the hour digits for the
alarm will flash.
6. Press / repeatedly to set hour. Press ENTER to confirm.