Installing The Base On The Wall; Preparing For The Installation Of The Monitor - Sony Bravia series Handbuch

Fit Base Adaptor I by using Screw (PSW 4x10)
J to Base (20) A when selecting 2-a.
J J
A
I
J J
4
Decide the positions of the screws for
installing the Base (20) A.
Refer to the specifications on page 25.
When selecting 2-a, please use the hole
positions of Base Adaptor I.
WARNING
• The wall that the Monitor will be mounted on
should be able to support a weight of at least
four times that of the Monitor (Refer to your
Monitor's Reference Guide for its weight.).
• Determine the strength of the wall the Monitor
will be mounted on. Reinforce the wall
sufficiently, if necessary.

Installing the Base on the wall

• Use four or more screws of 8 mm diameter or
equivalent (not supplied).
• Fit four screws to the holes of Base Adaptor
I with Base (20) A (2-a only).
• Install the Base (20) A on the wall
horizontally.
2-a
I
A
2-b
J J
I
J J
Preparing for the installation of the
Monitor
Refer to the Setup Guide for stand installation.
1
A
Remove the screws from the rear of the
Monitor.
FW-65BZ35F, FW-55BZ35F
FW-49BZ35F, FW-43BZ35F
GB
21
GB