Sony CBK-NC01 Installationsanleitung Seite 18

Note
Put the WRR cover plate and the
WRR installation assembly aside
for later use, as they will be
required when attaching a WRR-
855 UHF Synthesizer Tuner Unit.
3
Insert the CBK-NC01 into the slot.
Be sure to insert the CBK-
NC01slowly to avoid damaging
the connector.
18
4
Make sure the connector at the
bottom of the slot firmly couples
with the connector on the CBK-
NC01. Then securely tighten the
four screws (+B2.6 × 10) on the
CBK-NC01.
Note
While tightening the screws, keep
the CBK-NC01 pressed towards
the front end of the camcorder.
5
Attach the ferrite core to the
network cable.
Notes
• If the ferrite core is not attached
to the cable, radiation noise may
affect the electronic devices
nearby.
• To conform to radiation
standards, attach the supplied
ferrite core to the cable.