Maintenance; Maintenance Activities; Spark Plug (Every 50H); Cleaning - Zipper Zi-Bts350 Betriebsanleitung

 No Dry cutting saw blades are suitable for wet cutting.
 No curves intersect. Not inclined to fix blade material.

17 MAINTENANCE

17.1

Maintenance activities

 Check the engine oil level before each use
 Check the belt tension and adjust as required by these-6.1.3-
 Lubricate the bearings of the diamond saw blade axis daily
 Before each use, the blade is in good condition and tight fit
 Before each use the air filter is clean.
 Before each use screw connections for tightness
 Air filter (every 100 hours)
1. Remove the air filter.
2. Clean it in a solution.
3. Drops of engine oil on the air filter.
4. Waste engine oil to remove from the air filter by wring it out.
CAUTION: NEVER WITHOUT ENGINE AIR FILTER OR MAINTAINTED
AIR FILTER WITH NOT OPERATE
17.2

Spark plug (every 50h)

 Remove the spark plug contact.
 Remove any debris with a brush.
 Inspect the spark plug for discoloration.
 Check the contact gap. Standard: 0.7 ~ 0.8mm

17.2.1 Cleaning

Cleaning: The use of paint thinners, gasoline, corrosive chemicals or abrasive cleaners
will result in damage to the surface!
Therefore:
Z.I.P.P.E.R Maschinen Austria  www.Zipper-maschinen.at
Betontrennschneider / Concrete cutter ZI-BTS350
.
N O T E
When cleaning, use only mild detergent
MAINTENANCE
(Picture 19)
(Picture 18)
Seite 28