Hardwareinstallation - Velleman CAMTVI14WN Bedienungsanleitung

 Damage caused by disregard of certain guidelines in this manual is not
covered by the warranty and the dealer will not accept responsibility for
any ensuing defects or problems.
 Keep this device away from extreme heat.
 Protect this device from shocks and abuse. Avoid brute force when
operating the device.
 Do not use this product to violate privacy laws or perform other illegal
activities.
4. Features
 weatherproof
 with B/W night vision (IR LEDs)
 1080P video signal
 vandal-proof housing
5. Overview
Refer to the illustrations on page 2 of this manual.
1 sunshield
2 lens
6. Hardware installation
Refer to the illustrations on page 2 of this manual.
 Choose a location for the camera, keeping following guidelines in mind:
do not install the camera in locations where extremely high or low
o
temperatures or excessive vibrations may occur.
avoid mounting the camera near high electro-magnetic fields.
o
do not aim the camera at the sun or other extremely bright objects
o
or reflections (e.g. metal doors).
 Use the mounting bracket to determine the location of the mounting
holes. Drill the holes and secure the bracket using screws.
 Connect the two wires for an analogue PAL signal; leave them
unconnected for a HD 1080P TVI signal.
 Connect the power connector to the 12 VDC power supply (not incl.).
 Connect the BNC connector to a monitor (not incl.).
 Point the camera towards the field of interest and tighten the position bolt.
V. 01 – 04/07/2019
CAMTVI14WN
4
5
4
light sensor
bracket
©Velleman nv