Oase Varionaut 90 24V/DMX/02 Gebrauchsanleitung Seite 23

RDM parameters
General parameters
STATUS_MESSAGES
STATUS_ID_DESCRIPTION
SUPPORTED_PARAMETERS
PARAMETER_DESCRIPTION
DEVICE_INFO
DEVICE_MODEL_DESCRIPTION
MANUFACTURER_LABEL
DEVICE_LABEL
SOFTWARE_VERSION_LABEL
DMX_START_ADDRESS
SENSOR_DEFINITION
SENSOR_VALUE
IDENTIFY_DEVICE
DEVICE_HOURS
DEVICE_POWER_CYCLES
RESET_DEVICE
Specific parameters
CURVE_X1
CURVE_Y1
CURVE_X2
CURVE_Y2
CURVE_X3
CURVE_Y3
RUNTIME_HOURS
STARTUP_COUNTER
GET SET Description
CMD CMD
Used to manage status messages
•
•
Overview of all RDM parameters
•
Description of all parameters
•
Brief overview of the most important features
•
Type designation
•
Manufacturer's designation
•
Labelling field
• •
Firmware version number
•
Reading and setting the DMX start address
• •
Sensor information
•
Sensor values
• •
Sensor 1 TempErrCount
Sensor 2 MotorFailureCount
Sensor 3 ActualSpeed
Sensor 4 NominalSpeed
Sensor 5 PWM
Sensor 6 Temp
Sensor 7 PowerVoltage
Sensor 8 CurrentConsumption
0 = Normal operation
• •
1 = The pump will switch on and off again at short intervals. This function is helpful
for identifying the device in the field.
Operating hour counter, total
•
Counter for cold startup/switch-on
•
Executes a reset
•
1 = Warm start
255 = Cold start
GET SET Description
CMD CMD
•
Support value 1 of the stored pump characteristic curve
•
•
Support value 2 of the stored pump characteristic curve
•
•
Support value 3 of the stored pump characteristic curve
•
Operating hour counter for the running period
•
Startup counter
•
Temperature error counter
Motor failure counter
Current actual speed
Current set point speed
Current PWM value
Current operating temperature
Current voltage
Current current consumption
- EN -
23