First Start-Up; Inverter Configuration - Riello RS 68/EV Anleitungen Für Einbau, Betrieb Und Wartung

4

First start-up

4.1

Inverter configuration

Notes on safety for the first start-up
The first start-up of the inverter kit must be carried
out by qualified personnel, as indicated in this
manual and in compliance with the standards and
regulations of the laws in force.
WARNING
Check the correct working of the adjustment, com-
mand and safety devices.
WARNING
The Inverter must be configured before it is started.
• Open the Inverter board.
• Set the analogue inputs as explained below by means of DIP
switches on the I/O module, located under the operator panel,
(see Fig. 15)..
In case of LMV52 ... (See detail A)
DIP switch 1
Analogue input 1:
DIP switch 2
Analogue input 2:
In case of REC37 ... (See detail B)
DIP switch 1
Analogue input 1:
DIP switch 2
Analogue input 2:
• Power up and set the "0-AUTO" or "0-1" selector of the burner
to "0".
6112
current 0...20 mA
ON
current 0...20 mA
ON
0 - 10 V
OFF
0 - 10 V
OFF
First start-up
• Carry out a quick commissioning.
To this end, some information regarding the Basic Operator
Panel (BOP) is summarised below for you to consult first,
along with the different keys and their functions and an
example of parameter editing (see page 11, page 12 and
page 13).
Should you require further details, consult the Reference Manual.
I/O Module
DIP switch to set ana-
logue inputs
A
ON
1 2
B
OFF
1 2
10
GB
ON
2 0 2 1 2 2 2 3 2 4 2 5
1 2
1 2 1 3 1 4 1 5 1 6 1 7 2 6 2 7 2 8
1 2 3 4 5 67 8
D8194
S8150
2 9 3 0
9 1 0 1 1
Fig. 15