Functional Description; Operation - Makita 6951 Bedienungsanleitung

WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Switch action
Fig.1
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
Reversing switch action
Fig.2
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the A
side for clockwise rotation or from the B side for
counterclockwise rotation.
CAUTION:
Always check the direction of rotation before
•

operation.

Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing driver bit or socket bit
Fig.3
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
A = 17 mm To install these types of bits, follow the procedure (1).
B = 14 mm (Note) Makita bits are these types.
To install these types of bits, follow the procedure (2).
(Note) Bit-piece is necessary for installing the bit.
A = 12 mm
B = 9 mm For European and North & South American countries.
Use only these type of bit. Follow the procedure (1).
(Note) Bit-piece is not necessary.
006418
1. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far
as it will go. Then release the sleeve to secure the
bit.
Fig.4
2. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit-piece and bit into the
sleeve as far as it will go. The bit-piece should be
inserted into the sleeve with its pointed end facing
in. Then release the sleeve to secure the bit.
Fig.5
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.
OPERATION
Hold the tool firmly and place the point of the driver bit in
the screw head. Apply forward pressure to the tool to the
extent that the bit will not slip off the screw. Start the tool
slowly and then increase the speed gradually. Release
the switch trigger just as the screw bottoms out.
The proper fastening torque differs depending upon the
kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. Refer to the figure for the
relation between fastening time and wood screw size.
(Material to be fastened: Lauan)
(S)
6
5
4
3
2
1
ł3.8 ł4.0
x 50 x 65
Screw size
002839
NOTE:
Use the proper bit for the head of the screw/bolt
•
that you wish to use.
4
ł4.2 ł4.5
x 90 x 120
mm