Specifications; Ec Declaration Of Conformity; Specific Safety Rules - Makita 6951 Bedienungsanleitung

ENGLISH
1-1. Switch trigger
2-1. Reversing switch lever
4-1. Bit
4-2. Sleeve

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute
Max. fastening torque
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 92 dB (A)
sound power level: 103 dB (A)
Uncertainty: 3 dB(A)
Wear ear protection.
The typical weighted root mean square acceleration
2
value is 8 m/s .
These values have been obtained according to
EN60745.
For Model 6951
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 89/336/EEC, 98/37/EC.
Yasuhiko Kanzaki CE2005
Explanation of general view
5-1. Bit
5-2. Bit-piece
5-3. Sleeve
6-1. Limit mark
Model
Machine screw
Standard bolt
High tensile bolt
-1
)
Overall length
Net weight
Safety class
ENE033-1
000087
ENF002-1
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan

SPECIFIC SAFETY RULES

ENG006-2
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to impact driver safety rules. If you use this tool
unsafely or incorrectly, you can suffer serious
personal injury.
1. Hold power tools by insulated gripping
surfaces when performing an operation where
the cutting tool may contact hidden wiring or
its own cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and shock
the operator.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
ENH101-5
3. Hold the tool firmly.
4. Wear ear protectors.
SAVE THESE INSTRUCTIONS.
3
7-1. Screwdriver
7-2. Brush holder cap
6951
4 mm - 8 mm
6 mm - 12 mm
6 mm - 12 mm
0 - 2,200
0 - 3,000
98 N.m
239 mm
1.3 kg
/II
Director
GEB012-2