Preparations; Using A Lithium Battery; Mounting The Unit In A Rack - Sony SVRM-911 Bedienungsanleitung

Preparations

Note
Please consult your Sony dealer for installation of the
unit.

Using a Lithium Battery

A lithium battery is preinstalled in the unit at shipping.
Perform the steps below to store the date and User ID
data.
1
Turn on the unit and check to see that the LED
display lights up.
2
Set the BATTERY switch on the rear panel to ON.
When a lithium battery is not used
When it is not necessary to save any data, this unit can
also be used without inserting a lithium battery or with
the BATTERY switch set to OFF. Control of
duplicators will not be affected if a lithium battery is
not installed. (If the BATTERY switch is set to ON
when no battery is installed, the LED display will
blink.)
See "Replacing the battery" for instructions on how to
remove the battery.
Replacing the battery
When the lithium battery becomes weak, the LED
display blinks. In this case, replace the battery with a
Sony CR2025 lithium battery. Use of another battery
may present a risk of fire or explosion. The normal
battery life is about 1 year.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble or dispose of in fire.
Keep the lithium battery out of the reach of children.
Should the battery be swallowed, consult a doctor
immediately.
1
Turn off the unit.
2
Set the BATTERY switch to OFF.
18
3
Open the cover of the battery compartment and
remove the battery.
Battery
Cover
4
Insert a new battery and close the cover.
Cover
5
Set the BATTERY switch to ON.

Mounting the Unit in a Rack

To mount the unit in an EIA standard 19-inch rack, use
the supplied rack mount angles.
1
Attach the supplied rack mount angles to the unit
using the supplied screws (+B, M4) (4 mm or
3
/ inches).
16
Rack mount angles
2
Screw the rack mount angles to the rack.
For more information about usable racks, contact your Sony
dealer.
Battery
compartment
New battery