Detecting And Selecting The Available Channels Automatically (Urx-M1 Only) - Sony UWP-X5 Bedienungsanleitung

2
Press the SET button repeatedly until
the frequency indication appears and
starts flashing.
3
Press the + or – button to select the
frequency.
4
When the desired frequency appears,
leave the tuner for about 10 seconds
until the selected channel frequency
stops flashing and the selection is
stored in memory.
Notes
• When you are setting the reception
channel, the tuner can be used to receive
signals.
• Do not remove the batteries while setting
the reception channel. If they are
inadvertently removed, re-insert them
immediately and redo the procedure
"Setting the reception channel (URX-M1
only)" from step 1.
• Make sure that the selected channel is the
same on the transmitter and tuner being
used in the same system.
• If you turn off the tuner and then
immediately turn it on right after setting
the reception channel, the unit may not
operate normally. Wait a few seconds
before turning it on again.
Detecting and selecting the
available channels
automatically (URX-M1
only)
When multiple diversity tuner modules
(URX-M1) are installed into the MB-X6 to
perform simultaneous multiple-channel
24 Settings
operation, select the channel group on the
tuner module installed into the slot 1 of
the MB-X6, then all the tuner modules
installed into the MB-X6 can be set to
different channels within the selected
channel group.
1
Turn off all the microphones and
transmitters.
2
Select the channel group on the tuner
module installed into the slot 1 of the
MB-X6.
3
After confirming that the channel
group indication has stopped flashing
(about 10 seconds after you have
selected the channel group), keep
pressing the + button on the tuner
module installed into the slot 1 of the
MB-X6.
All the tuner modules installed into the
MB-X6 are set to the available
channels within the selected channel
group.
After the automatic detection and
selection of available channels finish,
you can change the group and channel
on each tuner module manually.
Notes
• Do the automatic detection and selection
of available channels with the channel
group other than channel group 00.
• When there are unavailable channels due
to extraneous radio wave and the channel
could not be selected on some tuner
modules, "NO CH" appears on the
display of those tuner modules. If this
happens, select the channel group with no
interference from extraneous radio wave,
and repeat the procedure above.