Battery Indication - Sony UWP-X5 Bedienungsanleitung

2
Align two new LR6 (size AA) alkaline
batteries with the polarity markings
and insert them into the battery
compartment, and then close the cover.

Battery indication

When you turn the power on, the battery
condition is shown by the BATT indication
in the display section.
When the indication in column 4 starts to
flash, replace the batteries with new ones.
Be sure to check the expiration date printed
on the new batteries before using them.
BATT Battery status
indication
1 Lights Good
2 Lights Less than 50%
charged
3 Lights Less than 20%
charged
4 Flashes Almost drained
Note
The indicated battery condition may not be
correct if the batteries were not new when
installed. If you plan to use the component
for a long period, it is recommended that
you replace the batteries with brand new
ones.
Notes on battery
Batteries may leak or explode if mistreated.
Be sure to follow these instructions.
• Be sure to install the batteries with the
correct polarity.
• Always replace the two batteries
together.
• Do not use different types of batteries or
old and new one together.
• The batteries are not rechargeable.
• When not using the component for a long
period of time, remove the batteries to
avoid leakage. If the batteries do leak,
clean all leakage from the battery
compartment and the component.
Leakage left in the compartment and the
component may cause poor battery
contact. If there seems to be poor battery
contact, consult your Sony dealer.
Power Supply 17