Sony UWP-X5 Bedienungsanleitung Seite 2

English
For the UTX-B1
Transmitter
Owner's Record
The model and serial numbers are located at
the rear or on the bottom of the unit. Record
the model and serial numbers in the space
provided below.
Refer to these numbers whenever you call
upon your Sony dealer regarding this
product.
Model No. UTX-B1
Serial No. _____________________
Notice for customers in the
U.S.A.
Use of Sony wireless devices is regulated
by the Federal Communications
Commission as described in Part 74 subpart
H of the FCC regulations and users
authorized thereby are required to obtain an
appropriate license.
You are cautioned that any changes or
modifications not expressly approved in
this manual could void your authority to
operate this equipment.
IMPORTANT NOTE: To comply with
the FCC RF exposure compliance
requirements, no change to the antenna or
the device is permitted.
Any change to the antenna or the device
could result in the device exceeding the RF
exposure requirements and void user's
authority to operate this device.
This device complies with FCC radiation
exposure limits set forth for uncontrolled
equipment and meets the FCC radio
frequency (RF) Exposure Guidelines in
Supplement C to OET65. This device has
very low levels of RF energy that it is
deemed to comply without testing of
specific absorption ratio (SAR).
2
Notice for customers in Canada:
Use of Sony wireless devices is regulated
by the Industry Canada as described in their
Radio Standard Specification RSS-123.
A licence is normally required. The local
district office of Industry Canada should
therefore be contacted. When the operation
of the device is within the broadcast band,
the licence is issued on no-interference,
noprotection basis with respect to broadcast
signals.
Operation of this device is subject to the
following two conditions: (1) this device
may not cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
The term "IC:" before the radio certification
number only signifies that Industry Canada
technical specifications were met.
Remarque à l'intention des
utilisateurs au Canada:
L'usage des appareils sans fil Sony est
réglementé par l'Industrie Canada comme
décrit dans leur Cahier des Normes
Radioélectriques CNR-123.
Une licence est normalement requise.
Le bureau de l'Industrie Canada doit être
contacté. Lorsque le fonctionnement de
l'appareil respecte les limites de la bande de
radiodiffusion, la licence est accordée sur la
base d'une non-interférence, non-
protection pour les signaux de
radiodiffusion.
L'utilisation de cet appareil est soumise aux
deux conditions suivantes: (1) cet appareil
ne peut causer d'interférences, et (2) cet
appareil doit accepter toutes les
interférences, y compris les interférences
capables de provoquer un fonctionnement
non souhaité de l'appareil.
L'expression <<IC:>> avant le numéro
d'homologation/enregistrement signifie
seulement que les spécifications techniques
de l'Industrie Canada ont été respectées.