Setting The Reception Channel (Urx-M1 Only) - Sony UWP-X5 Bedienungsanleitung

the transmission channel, the unit may
not operate normally. Wait a few seconds
before turning it on again.
Setting the reception
channel (URX-M1 only)
Refer to the supplied leaflet "Sony Wireless
Microphone System Frequency List" for details on
the selectable channel groups and channels.
1
Press down the SET button for more
than one second.
Keep pressing the SET button until the
display section parameters start to
flash.
2
Press the SET button repeatedly until
the channel group and the channel
number indications appear.
The channel group indication starts to
flash.
3
Press the + or – button to select the
channel group.
Pressing the + button cycles the
indication in the order shown in the
tables in the supplied leaflet "Sony
Wireless Microphone System
Frequency List."
Pressing the – button cycles the
indications in the opposite direction.
Hold down the + or – button to change
the channel group faster.
4
When the desired channel group
number appears, press the SET button.
The selected group is entered.
The right four digits start to flash to
allow the selection of the channel
number.
5
Press the + or – button to select the
channel number.
The channel indication changes in the
order shown in the tables in the
supplied leaflet "Sony Wireless
Microphone System Frequency List."
Example: When the channel group 00 is
selected
6
When the desired channel number
appears, leave the tuner for about 10
seconds until the selected channel
number stops flashing and the
selection is stored in memory.
To select the channel by
frequency indication
1
Press the SET button for more than one
second.
Keep pressing the SET button until the
display section parameters start to
flash.
Settings 23